Incra Ultra Lite Manuel d'utilisateur

OWNER’S MANUALPlease read this Owner’s Manual beforeuse and keep it at hand for reference.In the few years since its first appearance inwoodworking sh

Attach the Incra Jig UltraLite to a 3/4” plywood base Begin with a piece of 3⁄4" plywood (orhardwood) that is 8" wide. The length of theplyw

Micro adjustingThe micro adjust feature of your new Incra Jig Ultra Lite allows forprecise positioning of the fence to any location between the 1⁄32&q

6Joint making represents one of the most exciting applications foryour new Incra Jig Ultra Lite. Just by applying a little technique tothe accuracy of

8FIG. 19Rout the test grooveRout the test grooveTurn the router on, and using a good rubber soled pushblock, cut a groove along the entire length of t

10The first cut on either the “A” or “B” series of cuts will bean open cut. This means youwill be cutting away the edge ofthe board adjacent to the fe

Tail CutsTo cut the tails for a half blind dovetail, begin bycutting a dovetail shaped rabbet on both ends of thetwo boards, see Figs. 33 and 33a. The

14All of the components and features of your new Incra JigUltra Lite have been factory set and should require nofurther adjustment. If, however, you w

16Made in the U.S.A. by Taylor Design Group, Inc.0299Printed in the U.S.A. © 1999, 1996 Taylor Design Group, Inc. Incra is a registered trademark of T