Incra Build-It Panel Manuel d'utilisateur télécharger pdf (Page 4)

System

7. Trim Build-It Panel to Blade

Raise the saw blade about 3/4” and make a cut to trim off the portion

of the panel that extends beyond the line of cut, Fig. 9. Now, when

you return the left hand Build-It assembly to the table saw, the right

hand “drop panel” can be positioned adjacent to the blade and locked

in place by tightening the two Miter Slider expansion mechanisms to

provide workpiece cutoff support.

Fig. 9 Trim Build-It Panel to Blade

Fig. 10 Sliding Cutoff Sled

Fig. 11 T-Track Fence

Fig. 10 shows the completed Build-It assemblies put together to create

a very useful sliding cutoff sled. The wooden fence shown includes the

addition of INCRA’s T-Track and T-Track Plus, see Fig. 11 for dimensions.

The fence is held in place with a pair of Build-It Brackets and the knobs

included with the brackets. This arrangement allows the fence to be

positioned at any location and at any angle on top of the sled. The

workpiece is positioned with a user made wooden stop and is securely

held in place with the INCRA Build-It Clamp.

3/4” wide x 1/2”

deep groove

/4”

/8”

MADE IN THE

USA

Manufactured by:

Taylor Design Group, Inc.

P.O. BOX 810262 Dallas, TX 75381

www.incra.com

INCRA Tools are protected by one or more of the following US patents:

#4,793,604, #4,930,221, #5,195,730, #5,275,074, #5,423,360, #5,716,045, #6,237,457, #6,557,601, #6,672,190.

Other patents granted or pending.

INCRA is a Registered Trademark of Taylor Design Group

1 2 3 4

Pas de commentaire

Incra Build-It Panel Manuel d'utilisateur Page 4